The broom finish of the concrete is rough textured finished obtained by dragging a broom on the trowelled surface of the concrete while the concrete is still fresh.
Broom finish concrete slab.
This helps form a consistent border for the broom part of the concrete slab finish.
Pour the slab strike off with a screed bull float wait for the bleed water to evaporate although with low water cement ratio exterior concrete with the proper amount of.
However do not undo your work by allowing people to use it immediately.
Trowel there s some disagreement here.
That s about 5 400 or between 3 600 and 7 200 for a typical 30 by 30 foot slab that s 6 inches deep.
The typical process for a broom finish is.
Concrete slabs typically cost about 6 per square foot or between 4 and 8 per square foot including labor.
One is you could grind or polish the surface which would remove the rough broom finish and smooth the surface of the concrete.
Give the cement adequate time to dry off before allowing people to walk on the concrete slab.
If you re broom finishing a concrete patio pool deck sidewalk or a driveway the basics are the same.
Use the edging trowel to round off the edges of the concrete slab and make a flat margin.
Some of the aggregate would be exposed giving you a nice smooth decorative look to your sidewalk and patio.
Materials alone cost about 4 per cubic foot.
Dragging of broom on the fresh concrete surfaces creates small ridges that provide for traction control and slip resistant.
As with all the other finishing steps the key to a successful broom finish is to wait until the concrete surface is just right.
There are two things you can do fix the rough finish.
If concrete starts to pile up in front of the bristles as you drag the broom across resmooth the broomed area with a float or trowel and then wait a little longer before trying again.
Dragging a house broom or a garage broom across the troweled concrete after it dries a little produces light texture lines.
If you want a non slip surface on your concrete then a broom finish is what you re looking for.
For a deeper texture forgo the trowel and drag your broom across the concrete while it s still wet but after you complete the floating.
Drag a stiff bristled broom one made from horsehair or nylon slowly across the surface.
Ensure each stroke is consistent traveling in the same direction and creating tiny ridges in the surface.
In my opinion learning how to do a broom finish is a little easier than doing a smooth steel trowel finish.
Resurfacing this concrete slab took years off its appearance but it s still important to give this slab a broom finish.